1、0.3um ultra fine particles,makes it have both toughness and hardness,high speedand long time cutting could be true. 2、The super lubrication of TXcoating surface,makes the friction coefficient of the coating surface lower cutting resistance and cutting temperature will be greatly reduced;On the basis of the original AICr series coating,adding Si element can effectively increase the toughnessand reduce the residual stress in the coating.Long time cutting can be realized under dry and wetconditions.Compared with traditional coating,it has higher wear resistance and versatility. 3、TX coating is very suitable for cutting most of HRC52 materials, widely used in cutting general carbonsteel,pre-hardened steel(<HRC55） ,stainless steel,copper,acrylic and ect.

1、0.3um ultra fine particles, makes it have both to-ughness and hardness, high speed and long time cutting could be true. 2、The super lubrication of ATX coating surface,makes the friction coefficient of the coating surface lower,cutting resistance and cutting temperature will be greatly reduced; 3、ATX coating is very suitable for cutting the materials of HRC40-55,widely used to the processing of high-precision moulds such as car lamp moulds, mobile phone moulds and hardware moulds, etc.

1、0.3um ultra fine particles, makes it have both to-ughness and hardness, high speed and long time cutting could be true. 2、The super lubrication of ATX coating surface,makes the friction coefficient of the coating surface lower,cutting resistance and cutting temperature will be greatly reduced; 3、ATX coating is very suitable for cutting the materials of HRC40-55,widely used to the processing of high-precision moulds such as car lamp moulds, mobile phone moulds and hardware moulds, etc.

1、0.3um ultra fine particles, makes it have both to-ughness and hardness, high speed and long time cutting could be true. 2、The super lubrication of ATX coating surface,makes the friction coefficient of the coating surface lower,cutting resistance and cutting temperature will be greatly reduced; 3、ATX coating is very suitable for cutting the materials of HRC40-55,widely used to the processing of high-precision moulds such as car lamp moulds, mobile phone moulds and hardware moulds, etc.